Can you split a floor in Revit?

How do you cut a floor in Revit?

Cut an Opening in a Floor, Roof, or Ceiling

1. Click By Face or Vertical. Where is it? Architecture tab Opening panel. Structure tab Opening panel. …
2. If you chose By Face, select a face in the floor, ceiling, or roof. If you chose Vertical, select the entire element. Selected face for opening by face. …
3. Click Finish Opening.

How do you add another floor in Revit?

Example

1. Click Modify tab Geometry panel (Paint).
2. In the Material Browser dialog, select a material. Note that you can only browse for a material when you select the paint tool.
3. Place the cursor on the element face to highlight it. …
4. Click to apply the paint.
5. In the Material Browser dialog, click Done.

How do you make multiple floors in Revit?

Add Levels

1. Open the section or elevation view to add levels to.
2. On the ribbon, click (Level). Architecture tab Datum panel (Level) …
3. Place the cursor in the drawing area and click. …
4. Draw level lines by moving the cursor horizontally. …
5. Click when the level line is the correct length.

How do you split a face in Revit?

Revit – Split Face

1. Go to the Modify tab.
2. In the “Geometry” group click the Split Face button.
3. Select the surface you wish to split.
4. Using the draw tools draw a boundary around the surface you wish to split.
5. Click the green tick in the Ribbon bar to finish.

How do you cut a roof in Revit?

Choose “Void extrusion” to create an In-place family roof. Pick the line on the base of the inside edge of the roof to draw the void in a section view. The “cut geometry” command can be used to select the roof over the void. To execute the cut, click “Finish” after that.

How do I cut a hole in the floor of my stairs?

Measure the length of the stairway opening, and cut two pieces of lumber that match the width of the existing joists and the length of the opening. For example, if the floor joists that you cut are 2-by-8s and the hole is 72 inches long, you need two 2-by-8s cut to 72 inches.

How do I make a floor family in Revit?

How To: Create a Compound Floor or Slab

1. Start the one of the floor or slab commands.
2. In Properties, select a type similar to the one you want to create and click Edit Type.
3. In the Type Properties dialog box, click Duplicate….
4. In the Name dialog box, enter a name for the new type and click OK.

How do you edit floors in Revit?

Edit a Floor Sketch

1. In a plan view, double-click the floor, or select the floor and click Modify | Floors tab Mode panel Edit Boundary. Watch the tooltip and the status bar to be sure you select the floor, not another element. …
2. Use sketching tools to change the boundaries of the floor.
3. Click Finish Edit Mode.