Best answer: How do you do model contours in Revit?

How do you create a contour model in Revit?

Create a Toposurface by Placing Points

1. Open a 3D view or a site plan view.
2. Click Massing & Site tab Model Site panel (Toposurface).
3. On the Options Bar, set a value for Elevation. …
4. Next to the Elevation text box, select one of the following: …
5. Click in the drawing area to place points. …
6. Click (Finish Surface).

How do you add topography in Revit?

In Revit, link the topography to the current model as follows:

1. Specify coordinates for the building model. …
2. Open a plan view or a 3D view for the building model. …
3. Click Insert tab Link panel (Link Topography).
4. In the Link Topography dialog, navigate to the topography. …
5. Select the desired topography, and click Link.

What is a topographic model?

Topographic models consist of a scaled down version of an area of land and contours that show change in elevation. … Topographic models are most easily created directly from topographic maps that show the contours of the land, although this is not absolutely necessary.

What is contour architecture?

Technically defined, a contour is an imaginary line that connects all points of equal elevation above or below a fixed reference plane or datum. … A contour line is the graphic representation of a contour on a plan or map.

Where are Revit site settings?

To access the Site Settings dialog, click the dialog launcher on the Model Sight panel. In the Site Settings dialog, you can modify the contour line display by adding contours. To do this, click Insert. Change the Start, Stop, and Increments values and select the desired Range Type and Subcategory.

How do you add thickness to topography in Revit?

To create the thickness you either create a copy of the 3D view or work in the default 3D view. 2. You then switch on the section box in view properties dialog. slightly into your 3D surface until you see you Topography Cut pattern appears.

How do you change Toposurface in Revit?

Open a site plan that displays a toposurface. Click Massing & Site tab Modify Site panel (Subregion). Revit enters sketch mode.

…

1. Select the subregion.
2. Click Modify | Topography tab Subregion panel (Edit Boundary).
3. Click (Pick Lines) or use other sketching tools to modify the subregion on the toposurface.